GB/T 14457.2-1993 单离及合成香料 沸程测定法

作者:标准资料网 时间:2024-05-20 07:32:05   浏览:9252   来源:标准资料网
下载地址: 点击此处下载
基本信息
标准名称:单离及合成香料 沸程测定法
英文名称:Isolate and synthetic aroma chemicals. Method for determination of distillation range
中标分类: 轻工、文化与生活用品 >> 日用化工品 >> 香精、香料
ICS分类: 化工技术 >> 化工产品 >> 香精油
替代情况:QB 802-1981
发布部门:国家技术监督局
发布日期:1993-06-05
实施日期:1994-01-01
首发日期:1993-06-05
作废日期:1900-01-01
主管部门:中国轻工业联合会
提出单位:中华人民共和国轻工业部
归口单位:全国香料标准化中心
起草单位:轻工业部香料工业科学研究所
起草人:杜世祥、黄振卿
出版社:中国标准出版社
出版日期:1900-01-01
页数:8页
适用范围

本标准规定了用蒸馏法测定液体单离及合成香料沸程的方法。
本标准适用于沸点在30^-300℃范围内,并且在蒸馏过程中化学性能稳定的液体单离及合成香料沸程的测定。

前言

没有内容

目录

没有内容

引用标准

没有内容

所属分类: 轻工 文化与生活用品 日用化工品 香精 香料 化工技术 化工产品 香精油
下载地址: 点击此处下载
Product Code:SAE J1476
Title:Parking Brake Structural Integrity Test Procedure Vehicles Over 4500 kg (10 000 lb) GVWR - Truck and Bus
Issuing Committee:Truck And Bus Foundation Brake Committee
Scope:This SAE Recommended Practice establishes a method of evaluating the structural integrity of the parking brake system of all new trucks, buses, and combination vehicles designed for roadway use in the following classifications: TRACTOR, TRAILER, TRUCK, AND BUS: over 4500 kg (10 000 lb) GVWR.Product Code:SAE J635
Title:Fan Hub Bolt Circles and Pilot Holes
Issuing Committee:Cooling Systems Standards Committee
Scope:The purpose of this SAE Recommended Practice is to encourage the standardization of mounting patterns for engine cooling fans as new engines are designed and developed in SI metric units. It is specifically not the objective of the specification to address the soft metric conversion of existing mounting patterns on engines designed in English units. The scope of the specification is limited to heavy-duty diesel engine manufacturers, fan suppliers, and end users. Standard mounting patterns are given for fans up to 2000 mm rotating diameter. Passenger car and light-duty fans were not addressed because committee members issuing the specification felt that standards for these fans could be better addressed by personnel working in the market segments which use those fans. See Figure 1 and Table 1.Rationale for issuance of the specification is cost savings through reduction of part numbers and inventory. Failure to comply with this specification will result in the need to release and carry in inventory parts of identical blade geometry and construction, but with different mounting patterns.